Featured Products

Categories

Information

In-Process Gages

Page 1 of 1


click to see more
click to see more

D100 Gage Controller

The D100 Controller achieves both its power and its compact size through the inventive application of advanced DSP technology. At the same time it retains the operator-preferred analog meter for visual monitoring of stock-removal rate and cycle disturbances.






click to see more
click to see more

D500 Gage Controller

The D500 Gage Controller advances the art of process control. Whether your requirement is multi-feature, automatic-changeover grinder control or complex inspection-with-feedback, the D500 can be configured to meet your needs.






click to see more
click to see more

Model 88 Thru-Spindle Gage

The Model 88 Thru-Spindle Gage measures plunge ground workpiece IDís. The Model 88 gage is mounted inside the workhead spindle, allowing easy access for workpiece load/unload. The gage features Control Gagingís patented slip-clutch mechanism to cut gage setup time to less than 60 seconds. Quick setup also minimizes costly part changeover cost.






click to see more
click to see more

TF1/TF2 Thrufeed Centerless Gages

The TF1 and TF2 are general purpose gage fixtures that adapt to almost any thrufeed centerless grinder. The gage fixture mounts to the exit workrest of the grinder and feeds part measurement data to a high-resolution gage controller for real-time process analysis and grinder control.






click to see more
click to see more

TFN Precision Gage Fixture For Thrufeed Grinding

The TFN is a high accuracy dynamic gage fixture designed to measure parts at the small end of the thrufeed grinding range. The design appears simple, but the geometry has been diligently refined to assure precise measurement of parts as they flow off the workrest blade.






click to see more
click to see more

WG1 Single Finger Gage

In keeping with the tradition of innovation, Control Gaging is pleased to announce the introduction of the WG1 Gage. Machined from stainless steel and assembled to the highest standards, the WG1 Gage provides precise measurement under the most demanding conditions.

A single WG1 can be used as a locator, a height gage or any other application requiring one contact point. Two WG1 Gages can be combined to measure internal or external diameters.






click to see more
click to see more

WG2 Dual Finger Gage Head

Control Gaging invented the "quick setup" gage head more than 30 year s ago, slashing gage changeover time from 20 minutes to 30 seconds. Some of the gages built then are still holding close tolerances today.

The rugged design of the WG2 allows you to keep your spare parts inventory low. The integrated slip-clutch setup mechanism protects the gage from damage and allows quick recovery from most gage wrecks.